Hello! Welcome to Guilin GM Technology Industry Ltd.!

PRODUCTS

phones:0773-5850657

Fax:0773-5814532

Service:Miss.Yu

mobiles:Mr. Qin 18977333475

E-mail:5803731@163.com

Address:High-tech Zone Guilin, Guangxi, China Yi Feng South Road on the 16th

Mr. Qin
PRODUCTS
Current locations:Home >> PRODUCTS

GM2011

The contents are intended for quick guidance and supplement supplement to the user who is using GM2000Ccontroller.                      

Please read the standard manual for more details.

GM2000C controller has four variants as shown

Note1:GM2011C/GM2012Cwith RS485 interface,GM2011/GM2012 without RS485 interface.

Note2: GM2011C/GM2012C is taken as an example to describe in this manual.

1   KEY FUNCTION DESCRIPTION

 

 

Stop/ Reset

 

Can stop generator under mode of Manual/Auto; Can reset shutdown alarm;press this key at least 3 seconds to test panel indicators are OK or not (lamp test); During stopping process, press this again can stop generator immediately.

Start

Start genset under Manual or Auto mode.

Manual

Pressing this key will setthe the module as Module mode.

Auto

Pressing this key will setthe the module as Auto mode.

Running with load

controller is under manual testing mode. Under this mode, genset will run with  load automatic when gens are normal. (GM2011Cwithout).

Set/ Confirm

Enters into Set menu after pressing this, and can shift ursor to confirm.

Page up/increase

Screen scroll;Shift cursor and increase values.

Page Down/Decrease

Screen scroll;Shift cursor and decrease values.

2    PARAMETER EDITING

1.Parameter Setting

2.Information

3.Language

 

After controller powered on ,pressto enter the parameters setting menu item as shown:

1) presskey to enter the menu interface after controller started,choose 1.  (See    Fig1  

Fig1);

Input Password

 

        0000

 

 

2) presskey to enter parameter confinguration password confirm interface(See Fig2);

  When 1234 is input,part of the parameter can be set;when 0318 is input,all the        Fig2  

parameter can be set;

3) pressorkey to increase or decrease values;presskey to shift bit and confirm setting;

4) If password is correct,enter into parameter interface; pressorkey to choose parameter items;press key to

   Enter into current parameter setting memu;

5) If parameter within the range,the setting can be saved in internal FLASH of controller. If out of range,it can’t

be saved.

Note:Pressingkey at any time can exit the editor and return to main menu.